| Location | Meadowbank |
| Manufacturer | Wicks |
| Weight | 10kg |
WHAT IT DOES
A chop saw has a circular saw blade mounted on an arm that pivots up and down. It is used to make short cuts (for example, cutting a long piece of material to smaller lengths) and is suitable for cutting metal.
If you need to cut wood at an exact angle, consider using a mitre saw instead. For longer, straight cuts, consider a table saw.
A chop saw has a circular saw blade mounted on an arm that pivots up and down. It is used to make short cuts (for example, cutting a long piece of material to smaller lengths) and is suitable for cutting metal.
If you need to cut wood at an exact angle, consider using a mitre saw instead. For longer, straight cuts, consider a table saw.
Tilt and slide mitre saw
This Sliding Mitre Saw is ideal for cutting wood, laminated panels and plastic. The saw head can be tilted to the left and right for high flexibility in setting mitres on two sides. It has workpiece supports on two sides, a clamping device for reliable securing and a workpiece stop with rails that adjust to the left and right which enable safe, precise operation
Note that the O/I button is for the laser guide.
50cm x 60cm x height 40cm
SAFETY INFORMATION & PPE
Ensure the electrical cable is clear of the work area and cutting plane.
YOU MAY ALSO NEED
HOW TO USE IT
Position workpiece on the flat platform under the saw blade, and line it up with the blade of the saw. The cut line will be marked out on the platform or shown by a laser projected onto the workpiece. Clamp the workpiece in place. Pull the trigger on the handle and slowly bring the saw down through the material.
INSTRUCTIONAL VIDEOS
Note this video is a general introduction and is not specific to this exact tool. We always advise reading the manual if provided below, especially the safety advisories, before using any tools.
Ensure the electrical cable is clear of the work area and cutting plane.
- Safety glasses – Essential
- Ear protection – Essential
- Dust mask – Essential
YOU MAY ALSO NEED
- Specific blades – Essential Pick suitable for your project
HOW TO USE IT
Position workpiece on the flat platform under the saw blade, and line it up with the blade of the saw. The cut line will be marked out on the platform or shown by a laser projected onto the workpiece. Clamp the workpiece in place. Pull the trigger on the handle and slowly bring the saw down through the material.
INSTRUCTIONAL VIDEOS
Note this video is a general introduction and is not specific to this exact tool. We always advise reading the manual if provided below, especially the safety advisories, before using any tools.