210mm TCT Multipurpose Sliding Mitre Saw (ETL2336) Due 25/11/2024

WHAT IT DOES

A chop saw has a circular saw blade mounted on an arm that pivots up and down. It is used to make short cuts (for example, cutting a long piece of material to smaller lengths) and is suitable for cutting metal.

If you need to cut wood at an exact angle, consider using a mitre saw instead. For longer, straight cuts, consider a table saw.

 The FURY3-S sliding mitre saw is optimised to cut mild steel, non-ferrous metals, wood, even wood with embedded nails, and plastic with a single blade! No blade changes = Hassle free, fast & easy work!

It is safer, faster and more economical than abrasive metal cutting saws - when cutting mild steel the saw produces no heat, no burrs and virtually no sparks. The cuts are clean and cool to touch, creating an instant workable finish.

• 1500W Powerful Hi-Torque Motor
• 60mm x 300mm Cross Cut Capacity
• 0°-45° Bevel Cut
• 210mm (8-1/4”) blade

SAFETY INFORMATION & PPE

Ensure the electrical cable is clear of the work area and cutting plane.

• Safety glasses – Essential
• Ear protection – Essential
• Dust mask – Essential

Safety glasses, ear protection, and other PPE are available for a suggested donation at check out.

YOU MAY ALSO NEED

• Specific blades – Essential Pick suitable for your project

HOW TO USE IT

Position workpiece on the flat platform under the saw blade, and line it up with the blade of the saw. The cut line will be marked out on the platform or shown by a laser projected onto the workpiece. Clamp the workpiece in place. Pull the trigger on the handle and slowly bring the saw down through the material.


INSTRUCTIONAL VIDEOS

Note this video is a general introduction and is not specific to this exact tool. We always advise reading the manual if provided below, especially the safety advisories, before using any tools.